YAMAHA Servo Buddy SUITS: R1 / R6 / R6S / FZ1 / Vmax / WR250 / Raider /Roadliner

Fitment - Please note all bike models may not be listed below. To find the correct servo buddy for your bike please look up your bike in the Fitment Guide below then type the servo buddy code into our search bar.

Click here to see Servo Buddy fitment guide 

Yamaha 42-1160

Yamaha YZF-R6 2002-2020
Yamaha YZF-R6S 2006-2009 
Yamaha YZF-R1 2002-2020
Yamaha YZF-R1M 2002-2020
Yamaha FZ1 2006-2012
Yamaha FZ1000 2013-2015
Yamaha FZ10 2017-2019
Yamaha MT10 2016-2019
Yamaha Vmax 2009-2020
Yamaha Raider 1900 2006-2018 
Yamaha Roadliner 1900 2006-2014 
Yamaha Stratoliner 1900 2006-2014 
Yamaha WR250 (X&R models) 2008-2020

The Servo Buddy is a small, light weight servo fix that eliminates the need for the exhaust servo motor, which is not needed with any aftermarket exhaust system. These devices are typically called EXUP valves, SET valves or exhaust servos. Typically when you purchase an aftermarket exhaust, a small plate is included to bolt onto the top of the exhaust servo. The purpose of this plate is to restrict the servos movement so the bikes computer still thinks the exhaust valve is connected and working correctly, preventing the FI (fuel injection sometimes mistakenly called the F1) fault light from illuminating on the dashboard. 

The problem with these plates is they require you keep the servo motor installed, taking up a lot of valuable room that could be used for power commanders, traction control computers, quick shifters, or a huge variety of other accessories. Additionally, the servo motor is dead weight, providing no benefit. After all, half the benefit of that fancy exhaust system was to drop weight, right!

The servo buddy uses OEM connectors and easily snaps into place replacing the bulky servo motor. It can be zip-tied to the wire harness and takes up virtually no space. The body is shrunk wrapped rather than encased in a housing to provide the smallest footprint possible while blending into the factory wire loom. It works by electrically mimicking the working exhaust servo so the computer thinks all is well with the exhaust circuit preventing the FI light from coming on due to exhaust faults while still keeping the lights other functionality to warn you if anything else is wrong with the bike! Simply disconnecting the FI light or putting tape over it could mask potentially serious problems and lead to a damaged engine.

To provide a reliable long service life, all parts were spec'd out to meet military or automotive standards meaning the device is tolerant to a wide temperature range. Additionally, the entire circuit board has been encased in a thick epoxy potting compound to provide protection from moisture and vibration. It will be EXTREMELY reliable under all conditions, whether your ride street, race, track, or adventure ride.

Please Note: If you are unsure if this will fit your bike, unplug your servo motor check the connector/s and compare them to the pic provided. If you are still unsure please contact us before ordering as we can not be held responsible if the incorrect servo buddy is ordered.

This is a genuine product, beware of imitations!

Servo Buddy weight = 20grams (0.6oz)

We are an Australian-owned and operating business