BMW S1000RR 2015-2018 Carbon with Kevlar Tank Side Trim/Sliders Protectors

Free Shipping Australia Wide!

Fits - TANK:        BMW S 1000RR 15-18

Features:

• Brand New 100% Carbon Fibre Gas Tank Side Trim/Sliders.
• This product is genuine carbon fibre and is fully reinforced with Carbon Kevlar, the high press mold finish adds to the extra strength and protection. 
• Set contains left and Right tank trim/sliders. (Left/Right).
• High Gloss finish.
• Super strong 3M peel-and-stick adhesive.
• A definite must-have for all Racers, Track day riders, and those that want a little extra bling on their bikes. Not only do they look great on the bike but they can assist in protecting your tank from damage in the event of a drop/accident. 

Carbon Tank Sliders - Installation instructions
1. Before fitting, set the bike up in a clean dust-free area.
2. Make sure the area on the tank where the tank covers are to be fitted is completely clean and free from grease, wax, and other contaminants by cleaning thoroughly with a paint-safe solvent such as Brake Clean.
3. Test fit the tank covers so that you know exactly where they are going to fit and how they will line up on the tank.
4. Install the covers one at a time. Using a hairdryer or heat gun on a low setting carefully heat the application area and the adhesive tape on the rear of the cover so that it is warm, almost hot to the touch. Be careful not to overheat.
5. Once the tank and the adhesive tape in the cover have been warmed, carefully peel the sticker paper from the rear of the tank cover and mount it carefully to your tank and press hard.
6. Make sure that the covers are stuck on permanently and have a strong bond to the tank. If the covers are not sticking this can be fixed, but if the cover falls off and is damaged there is no warranty for this.

Please note: If you have problems with the tank covers not sticking to your bike you may need 3M 94 Adhesion Promoter. In some cases, contaminants left on the bike, such as silicon or wax polish can cause major problems with tank covers not adhering correctly. 3M 94 Primer creates a super-strong bond between your tank's paintwork and the cover's adhesive tape and the tank surface.

Please note: The tank side trim covers/sliders pictured on the bike are fitted to a Yamaha R6 08-16 tank. The remaining images are of the actual carbon fibre tank side trim covers/sliders being ordered.

WARRANTY
We do not provide a warranty against poor fitting, and or in conditions where grease, wax, or other contaminants have not been sufficiently removed prior to fitting and have caused loss of adhesion where the tank side trim covers/sliders fall off.

DISCLAIMER
Motorcycle riding and racing are inherently dangerous and can cause serious injury or death. The manufacturer, distributor, and seller of this product are not responsible for any injury or death caused by the use of this product. By opening this package the user agrees to hold the above-mentioned parties not responsible in case of accident, injury, or death.

We are an Australian-owned and operating business